Dsp3In1 Carpet Washer Kd2042

DSP KD2042 2-in-1 Carpet and Floor Cleaner | Effective Cleaning for Your Floors and Carpets

Experience a comprehensive and practical cleaning experience with the DSP KD2042 carpet and floor cleaner! This multifunctional appliance is designed to give you the power and efficiency to clean carpets and hard floors easily and quickly. Thanks to its pure copper motor and advanced tools, you'll be able to clean your surfaces with high efficiency.

Specifications:

🔋 Voltage: 220-240V

🔌 Output: 800W

🔄 Spin Speed: 800 RPM

🌡 Hot Air Temperature: 70°C

💧 Tank Capacity:

Clean Water Tank: 1.35L

Wastewater Tank: 1.25L

🚿 Suction Power: ≥18 kPa

📏 Cable Length: 6m

Get your DSP KD2042 carpet and floor cleaner now and start cleaning your home efficiently and quickly!

How to use:

​1. Preparation and Setup (Before Washing)

Dry Cleaning First: Before using the carpet cleaning machine, it is essential to vacuum the carpet or floor thoroughly to remove surface dust, hair, and stubborn dirt.

Filling the Clean Water Tank: Unscrew the top water tank (clean water tank). Fill it with warm water (not boiling to avoid damaging the plastic parts) and add the appropriate amount of carpet cleaning solution (according to the detergent package instructions). Replace the tank securely in its position.

Choosing the Right Brush: The machine comes with two types of rotating brushes (as shown in the picture):

Coarse Bristle Brush (Red): Designed for deep cleaning carpets and rugs.

Soft Brush (Gray): Designed for delicate hard floors to prevent scratching.

2. Basic Operation and Washing Instructions

Operation: Plug in the power cord, then press the main power button to start the machine.

Spray and Scrub: While pushing the vacuum forward, press the trigger (located on the top handle) to spray the water and detergent mixture onto the carpet. The rotating brush underneath will scrub the fibers deeply to loosen dirt and stubborn stains.

Suction Dirty Water: As you pull the vacuum back (towards you), release the trigger (do not spray). The machine will then powerfully suction the dirty water and debris into the lower "dirty water tank," leaving the carpet almost dry.

Tip: For faster drying, run the vacuum over the same area several times without pressing the spray trigger (suck only).

3. Using the Hose and Attachments (for Upholstery and Corners)

The machine comes with a flexible hose and a handheld tool for cleaning areas the main vacuum cannot reach:

Connection: Attach the flexible hose to its designated port on the machine, and connect the handheld tool (small brush) to the end of the hose.

Use: This mode is ideal for cleaning stains on sofas, curtains, car seats, or carpeted stairs. The handheld tool head has a special spray button. After spraying and scrubbing, the tool vacuums up the dirty liquid.

4. Regular Cleaning and Maintenance (Very Important for Maintaining the Device)

Emptying the Dirty Water Tank: As soon as the dirty water reaches the Max mark in the lower tank, or if you hear a change in the motor's sound, immediately stop the machine and empty the tank into the drain.

Washing the Parts: After cleaning is complete, unplug the device. Disassemble the dirty water tank, the lower rotating brush, and the filter, and wash them all with clean water to remove any accumulated lint or mud.

Drying: Allow all parts to air dry completely before reassembling and storing the device to prevent the formation of unpleasant odors or bacteria.