BISSELL SPOT CLEANER 3617Z

The BISSELL SpotClean Pro Max is designed to quickly and effectively remove deep stains from carpets, upholstery, seats, and even car interiors.
It sprays water and cleaning solution onto the stained area, then vacuums up the dirt and dirty water, leaving the surface cleaner and less damp.
It comes with a hose and attachments that help you reach corners and tight spaces, making it practical for everyday use in your home or car.
It's ideal for unexpected spills like coffee and juice stains, as well as pet messes, saving you time and money on cleaning.

Technical specification:

Power: 750W

Clean water tank capacity: 2.8L (2800ml)

Dirty water tank capacity: 2.2L (2200ml)

Hose length: 1.5m

Noise level: Approximately 82–84 dB

Suction power (as stated by some sellers): Up to 14,500 Pa

Cleaning path width: 15 cm

How to use:

1. Preparing and Preparing the Cleaning Solution

Remove the clean water tank: Remove the tank located on one side of the machine (usually the one without the "FULL" label) by lifting the handle and gently pulling it out.

Fill the tank: Open the lid and fill the tank with warm water (not boiling to protect the plastic parts) up to the "WATER" fill mark. Then add the Bissell cleaning solution up to the "FORMULA" mark.

Reinstall: Close the lid securely and replace the tank in the machine until it is fully seated.

2. Preparing the Vacuum Hose and Tool

Unscrew the flexible hose from its loop around the machine.

Choose the appropriate tool (such as a standard hard-spot brush or ladder tool) and attach it to the end of the hose until it clicks into place.

Connect the power cord to a power source, then press the power button to turn on the machine.

3. Washing and Cleaning Methods (Spraying, Scrubbing, Vacuuming)
Spraying: Point the tool at the stain from a few centimeters away and press and hold the trigger (the button on the hose handle) to spray the cleaning solution and water onto the area to be cleaned.

Scrubbing: Use the brush bristles on the bottom of the tool to scrub the stain with a back-and-forth motion to help break down deep-seated dirt.

Vacuuming: Release the trigger (stop spraying), press the tool firmly down onto the fabric or carpet, and then pull towards you to vacuum up the dirt and remaining water. Repeat the vacuuming process (without spraying) until the stain disappears and no more water is being drawn up, to speed up the fabric drying process.

4. Emptying the Dirty Water and Cleaning After Finishing
Tank Monitoring: Monitor the dirty water tank (marked FULL). When the water reaches the maximum line, empty it immediately to prevent water leakage or reduced suction power.

Draining: Turn off the appliance, remove the dirty water tank, open the cover, empty the tank, and rinse it thoroughly with clean water.

Cleaning the hose (an important maintenance step): Before storing the appliance, it is recommended to siphon a small amount of clean water from an external container to rinse the inside of the hose and remove any remaining dirt. Then, lift the hose handle upwards for a few seconds to suction out any remaining water and dry it.

Storage: Unplug the appliance, wrap the cord and hose in their designated compartments, and store it in a dry place.