DEGRII ZIMA PRO Smart Cordless Robotic Pool Cleaner

Charge the battery first Fully charge the floating battery platform before use. Do not charge while the robot is running, and keep the charging connector dry. Install and check the filters Make sure the dual filter baskets are installed correctly and clean before placing the robot in the pool. Connect to the Degrii App Download the Degrii App, turn on Bluetooth, connect to 2.4GHz Wi-Fi, and follow the setup steps. The app lets you choose cleaning modes, schedule cleaning, use manual control, and use the Lift function. Turn on the robot Press the ON/OFF button on the floating battery platform. Select cleaning mode Choose from: Overall: floor + wall cleaning Floor: floor only Wall: wall + waterline cleaning Manual: control the robot from the app Put it in the pool correctly Place the robot in the water vertically to release trapped air. Make sure it sinks to the bottom and does not float. The manual says the robot must be in the water to operate and does not work on land. Start cleaning Start from the app or press the START button on the floating battery platform. The robot starts cleaning after about 15 seconds. Keep the floating battery clear Make sure the floating battery platform can move freely and is not blocked by pool edges, ladders, or objects. After cleaning When cleaning finishes or battery reaches around 10%, the robot moves toward the nearest pool edge. You can also use Lift in the app so the robot climbs the wall for easier removal. Remove and drain Lift the robot vertically from the water so the water drains out, then turn it off. Clean the filters Open the filter cover, remove both filters, empty debris, and rinse with clean water. If very dirty, clean with mild soapy water and a soft brush. Let the robot dry in a shaded dry place, not under direct sunlight.